Activity board for CANDIP/M162 This is the Activity board (ACB1) for CANDIP/M162 (or the old CANDIP/AVR1 and CANDIP/AVR1M products). With this board you get a quick start prototyping and testing CAN and your own system. Click on the photo for a larger picture showing all features of the Activity board. This board is great for educational purposes and a low cost alternative to wire up something on your own.

ACB1 Features

• Board covered with a ground layer on component side for good EMI performance.
• 28 pin DIP carrier for the CANDIP/M162.
• AC/DC power input in standard 2.1mm, not sensetive to polarity. 7-15V AC/DC. A 7805 that generates +5VDC and a green LED for +5V OK indication.
• ISP connector for In system programming (STK200 compatible) with red led for programming indication.
• Reset button.
• DB9 female for easy RS-232 connections.
• DB9 male for CAN (CiA standard DS102). Possible to feed other nodes via one power supply and the CAN cable (selectable via jumper).
• CAN Termination resistor (120ohm) selectable via jumper.
• 3 ea. jumpers for input, can work as Node addressing (0-7) or other settings.
• 4 buttons and 4 leds (all 4 buttons and leds cannot work at the same time, but it is possible via jumpers to select e.g. 3 leds and 1 button).
• Large prototyping area with all signals from CANDIP/M162 easy accessible from the ends including many for power and ground. SPI signals from CANDIP/M162 is not hooked up with LED's or buttons, so it easy to expand the I/O points with SPI slave devices.

Jumpers & LED configuration of Activity Board

CANDIP/M162

| Features | Schematics | Activity board | Starter kits | Software |

| Home | Information | News | Products | Download | Projects | Order | Dealers | Links |

© Copyright 2000-2003 LAWICEL. All rights reserved. Images and text used on these pages may not
be copied without written approval from LAWICEL. Information in this document is subject to change
without notice. Other products and companies referred to herein are trademarks or registered
trademarks of their respective companies or mark holders.

Contact webmaster@candip.com for reporting errors on these pages.

These pages where last updated 28/08/2003